DMM DMM WALL NUTS (ANODIZED) at Wilderness Exchange Unlimited

   There are lots of nuts on the market, but Wallnuts are amongst the best because of their design, the materials that they are made from and the attention to detail that goes into their manufacture.
   The end result is that the Wallnuts give secure placements even in difficult situations and their quality means that they will do this time after time, route after route.
   Pumped and scared, the last thing you need is to be fighting in a basic, square nut that won't seat properly or worse, won't place at all because the wire is too floppy to allow an accurate placement.

Features:

Complex 3D curves and scallops means secure and fast placement in all rock types.
DDM's accurate heat treatment processes on specifically chosen alloys maximises bite.
DMM counter sinks all the drilled radiuses in order to avoid stress points where the wire enters the nut.
The nuts are all well rumbled to remove sharp edges that can hinder placement
Hot forged from sizes 1 to 6 keeps strength high and weight to a minimum.
Extruded bar used on sizes 7 to 11 to reduce weight.
The wire used is chosen so that the nut can be placed at full reach without them flooping around.
A full size crimp because this is critical to safety
The label is on upside down so you can confirm the size more easily when the units are hanging on your harness. The label is double sealed so that it does not tear with time and use.
Joint collaboration with Wild Country to standardise color recognition. DMM make the light weight, coloured Rocks for Wild Country, but the basic, non-anodised, heavier WC Rocks are not made by DMM

Specs:

Size	Weight	Strength	Color
1	16 g	7 kn/ 4kn	Pink
2	26 g	9 kn	Green
3	28 g	11 kn	Silver
4	30 g	12 kn	Gold
5	34 g	12 kn	Blue
6	40 g	12 kn	Red
7	40 g	12 kn	Grey
8	45 g	12 kn	Turquoise
9	50 g	12 kn	Gold
10	56 g	12 kn	Silver
11	68 g	12 kn	Green